Common Pedal Issues
It sounds like you have inadvertently enabled the Kill Dry switch, which is located to the left of the power jack. This function is used primarily when plac...
Mon, 17 Feb, 2020 at 1:57 PM
Some of these may seem obvious, but they are all issues we have encountered on several occasions. Check your connections. INPUT is on the RIGHT side, and ...
Tue, 18 Feb, 2020 at 11:50 AM
Effects such as chorus, delay and reverb should be placed after gain; otherwise, your signal will be noisy. Hum or buzz is almost always caused by impro...
Tue, 18 Feb, 2020 at 11:47 AM
Is the dry signal ok but wet signal too quiet? If you are running mono with a stereo pedal, make sure to use only the #1 input and #1 output. Maxing out ...
Tue, 18 Feb, 2020 at 11:49 AM
Hum or buzz is usually caused by a ground loop and is more likely when running signal to two different places (like two different amps). The potential for g...
Tue, 18 Feb, 2020 at 11:45 AM